diesel Fuel incinerators
16. The supplier must provide necessary information for the best of the installation. This incinerator with “PYROLYTIC”
combustion must have:
17. A combustion chamber of waste:
Perfectly tight door for the manual loading of waste. The loading should be manual, batch load.
A burner of lighting which the use is limited to the ignition of waste.
Frontage of loading with door seals gone up on hinges, wheel of screw plug, flexible joint, and stuffing insulating out
of refractory.
The insulation of the combustion chamber should be composed of refractory bricks, having a high content of aluminium and
insulates bricks in order to assure a minimum temperature on the outside sheet metal.
Composition of the refractory;
Refractory concrete:
Thickness :>100mm
Nature: 42% of Al203
Insulate in fibrous panels:
Thickness: >75mm
Nature: Calcium silicate.
Burner of lighting of waste, with fuel, standard mono-bloc casting guiding plunging flame, lighting and safety of
electronic ignition, permanent ventilation, electromagnetic sluice gate of regulation and isolating valve.
Plate of combustion in Carborundum, avoiding the fixing of glass and slags.
18. A chamber of post combustion of gases
A burner of combustion of gases,
A device of injection of air allowing a total re-combustion of gases,
A device of air inlet of cooling of waste gases,
A sheath of evacuation of the gases burnt,
Carcass in strong sheet steel with support of connection
Composition of the refractory;
Refractory concrete:
Thickness :>150mm
Nature: 65%% of Al203
Insulate in fibrous panels:
Thickness: >85mm
Nature: Calcium
Burner with fuel, mono-bloc casting guiding type with horizontal flame, lighting and safety of electronic ignition,
permanent ventilation, electromagnetic sluice gate of regulation and isolating valve.
A secondary injection of air to ensure perfect oxygen content.
